2021 High quality Water Balancing Valve - TWS Flanged static balancing valve – TWS Valve

Short Description:


Product Detail

Product Tags

Related Video

Feedback (2)

, , ,
2021 High quality Water Balancing Valve - TWS Flanged static balancing valve – TWS Valve Detail:

Description:

TWS Flanged Static balancing valve is a key hydraulic balance product used for precise flow regulating of water pipelines system in HVAC application to ensure static hydraulic balance across whole water system. The series can ensure the actual flow of each terminal equipment and pipeline in line with the design flow in the phase of system initial commisiioning by site commissiong with flow measuring computer. The series are widely used in main pipes, branch pipes and terminal equipment pipelines in HVAC water system. It also can be use in other application with the same function requirement.

Features

Simplified pipe design and calculation
Quick and easy installation
Easy to measure and regulate water flowrate in site by the measuring computer
Easy to measure differential pressure in site
Balancing through stroke limitation with digital presetting and visible presetting display
Equipped with both pressure test cocks for differential pressure measurement Non rising hand wheel for convenience operation
Stroke limitation-screw protected by protection cap.
Valve stem made of stainless steel SS416
Cast iron body with corrosion resistant painting of epoxy powder

Applications:

HVAC water system

Installation

1.Read these instructions carefully. Failure to folow them could damage the product or cause a hazardous condition.
2.Check the ratings given in the instructions and on the product to make sure the product is suitable for your application.
3.Installer must be a trained, experienced service person.
4.Always conduct a thorough checkout when installation is completed.
5.For trouble-free operation of the product, good installation practice must include initial system flushing, chemical water treatment and the use of a 50 micron (or finer) system side stream filter(s). Remove all filters before flushing. 6.Suggest using a tentative pipe to do the initial system flushing. Then plumb the valve in the piping.
6.Do not use boiler additives, solder flux and wetted materials which are petroleum based or contain mineral oil, hydrocarbons, or ethylene glycol acetate. Compounds which can be used, with minimum 50% water dilution, are diethylene glycol, ethylene glycol, and propylene glycol (antifreeze solutions).
7.The valve may be installed with flow direction same as the arrow on the valve body. Wrong installation will lead to hydronic system paralysis.
8.A pair of test cocks attached in the packing case. Make sure it should be installed before initial commissioning and flushing. Make sure it isn’t damaged after installation.

Dimensions:

20210927165122

DN L H D K n*d
65 290 364 185 145 4*19
80 310 394 200 160 8*19
100 350 472 220 180 8*19
125 400 510 250 210 8*19
150 480 546 285 240 8*23
200 600 676 340 295 12*23
250 730 830 405 355 12*28
300 850 930 460 410 12*28
350 980 934 520 470 16*28

Product detail pictures:

2021 High quality Water Balancing Valve - TWS Flanged static balancing valve – TWS Valve detail pictures


Related Product Guide:

2021 High quality Water Balancing Valve - TWS Flanged static balancing valve – TWS Valve , The product will supply to all over the world, such as: , , ,

  • 5 Stars By from -

    5 Stars By from -
    Write your message here and send it to us

    Related products

    • Best Price for Kennedy Butterfly Valve - UD Series soft sleeve seated butterfly valve – TWS Valve

      Best Price for Kennedy Butterfly Valve - UD Se...

      UD Series soft sleeve seated butterfly valve is Wafer pattern with flanges ,the face to face is EN558-1 20 series as wafer type. Characteristics: 1.Correcting holes are made on flange according to standard, easy correcting during the installation. 2.Through-out bolt or one-side bolt used. Easy replacing and maintenance. 3.The soft sleeve seat can isolate the body from media. Product operation instruction 1. Pipe flange standards should conform to butterfly valve standards; suggest using weldi...

    • 2021 High quality Air Vent Valve For Heating System - TWS Air release valve – TWS Valve

      2021 High quality Air Vent Valve For Heating Sy...

      Description: The composite high-speed air release valve are combined with two parts of high-pressure diaphragm air valve and the low pressure inlet and exhaust valve ,It has both exhaust and intake functions. The high-pressure diaphragm air release valve automatically discharges the small amount of air accumulated in the pipeline when the pipeline is under pressure. The low-pressure intake and exhaust valve can not only discharge the air in the pipe when the empty pipe is filled with water, b...

    • Super Lowest Price Crane Butterfly Valve - DC Series flanged eccentric butterfly valve – TWS Valve

      Super Lowest Price Crane Butterfly Valve - DC ...

      Description: DC Series flanged eccentric butterfly valve incorporates a positive retained resilient disc seal and either an integral body seat. The valve has three unique attributes: less weight, more strength and lower torque. Characteristic: 1. Eccentric action reduces torque and seat contact during operation extending valve life 2. Suitable for on/off and modulating service. 3. Subject to size and damage, the seat can be repaired in the field and in certain cases, repaired from outside the...

    • New Arrival China Light Weight Check Valve - AH Series Dual plate wafer check valve – TWS Valve

      New Arrival China Light Weight Check Valve - A...

      Description: Material list: No. Part Material AH      EH BH MH 1 Body CI DI WCB CF8 CF8M C95400 CI DI WCB CF8 CF8M C95400 WCB CF8 CF8M C95400 2 Seat NBR EPDM VITON etc. DI Covered Rubber NBR EPDM VITON etc. 3 Disc DI C95400 CF8 CF8M DI C95400 CF8 CF8M WCB CF8 CF8M C95400 4 Stem 416/304/316 304/316 WCB CF8 CF8M C95400 5 Spring 316 …… Feature: Fasten Screw: Effectively prenvent the shaft from traveling,prevent valve work from failing and end from leaking. Body: Short face to f...

    • Manufacturer for Dutile Iron Y Type Strainer - TWS Flanged Y Magnet Strainer – TWS Valve

      Manufacturer for Dutile Iron Y Type Strainer -...

      Description: TWS Flanged Y Magnet Strainer with Magnetic rod for magnetic metal particles segregation. Quantity of magnet set: DN50~DN100 with one magnet set; DN125~DN200 with two magnet sets; DN250~DN300 with three magnet sets; Dimensions: Size D d K L b f n-d H DN50 165 99 125 230 19 2.5 4-18 135 DN65 185 118 145 290 19 2.5 4-18 160 DN80 200 132 160 310 19 2.5 8-18 180 DN100 220 156 180 350 19 2.5 8-18 210 DN150 285 211 240 480 19 2.5 8-22 300 DN200 340 266 295 600 20 ...

    • 100% Original Factory Butterfly Valve Dn250 - FD Series Wafer butterfly valve – TWS Valve

      100% Original Factory Butterfly Valve Dn250 - ...

      Description: FD Series Wafer butterfly valve with PTFE lined structure, this series resilient seated butterfly valve is designed for corrosive media, especially various kinds of strong acids, such as sulfuric acid and aqua regia. The PTFE material will not pollute media within a pipeline. Characteristic: 1. The butterfly valve comes with two-way installation, zero leakage, corrosion resistance, light weight, small size, low cost and easy installation.2. Tts PTFE clad seat is capable of protec...